Virpil Panel Label Kit
This kit provides both a blank plate cut for your chosen Virpil panel as well as 2 “generic label” cards for you to stick to the blank plate where you see fit. This allows you to pick and choose what labels you need for your given plate at a very affordable price point. An optional “Combat Card” can be added for a small fee to give you a more combat-specific set of labels. The labels are laser etched and cut and come in many different sizes. More common labels are duplicated in certain sizes to get all the details you need for your button commands.
This kit will fit the following Virpil Panels:
CP1
CP2
CP3/SharKa-50
CM3 Series Throttle
To install, remove any and all black toggle switch finger guards and remove the 4 corner faceplate screws(2 right most corner screws and left-center on the CM3 Throttle) install the panel, and replace at least 2 of the screws. Alternatively, you can click HERE and get a set of thumb screws so that after the initial “setup” no tools are required to swap panel plates.
This kit provides both a blank plate cut for your chosen Virpil panel as well as 2 “generic label” cards for you to stick to the blank plate where you see fit. This allows you to pick and choose what labels you need for your given plate at a very affordable price point. An optional “Combat Card” can be added for a small fee to give you a more combat-specific set of labels. The labels are laser etched and cut and come in many different sizes. More common labels are duplicated in certain sizes to get all the details you need for your button commands.
This kit will fit the following Virpil Panels:
CP1
CP2
CP3/SharKa-50
CM3 Series Throttle
To install, remove any and all black toggle switch finger guards and remove the 4 corner faceplate screws(2 right most corner screws and left-center on the CM3 Throttle) install the panel, and replace at least 2 of the screws. Alternatively, you can click HERE and get a set of thumb screws so that after the initial “setup” no tools are required to swap panel plates.
This kit provides both a blank plate cut for your chosen Virpil panel as well as 2 “generic label” cards for you to stick to the blank plate where you see fit. This allows you to pick and choose what labels you need for your given plate at a very affordable price point. An optional “Combat Card” can be added for a small fee to give you a more combat-specific set of labels. The labels are laser etched and cut and come in many different sizes. More common labels are duplicated in certain sizes to get all the details you need for your button commands.
This kit will fit the following Virpil Panels:
CP1
CP2
CP3/SharKa-50
CM3 Series Throttle
To install, remove any and all black toggle switch finger guards and remove the 4 corner faceplate screws(2 right most corner screws and left-center on the CM3 Throttle) install the panel, and replace at least 2 of the screws. Alternatively, you can click HERE and get a set of thumb screws so that after the initial “setup” no tools are required to swap panel plates.